Residential     Business
 

Programming the 4-Device Remote Control

Programming your 4-Device Remote Control - Auto-Scanning Method:

  1. Turn ON the device you wish to control (your TV or VCR).
  2. Point your remote control AWAY from the device.
  3. While pointing the remote away from the device, press and hold down the mode button for that device or and the button at the same time until the light on the remote blinks twice, then release both buttons.
  4. While pointing the remote AWAY from the device, press 9 9 1 on the number pad.
  5. Point the remote TOWARDS the device. Press the mode button for that device or , then press the button.
  6. Repeat this process of pressing the mode button then the power button until the device turns off.
  7. Once the device has turned off, press the button. The remote control LED will blink twice, confirming that you have successfully programmed your remote control.

Programming your 4-Device Remote Control - Manual Method:

  1. Find the code for the device you wish to control using the Remote Code-Finder.
  2. Turn ON the device you wish to control (your TV or VCR).
  3. Point your remote control AWAY from the device.
  4. While pointing the remote away from the device, press and hold down the mode button for that device or and the button at the same time, until the light on the remote blinks twice then release both buttons.
  5. While pointing the remote AWAY from the device, enter the code for that device on the number pad.
  6. Point the remote TOWARDS the device. Press the button to test operation.
  7. If the device has turned off, press the button. The remote control LED will blink twice, confirming that you have successfully programmed your remote control. If the device did not turn off, try these instructions again using a different code, if more than one was listed. Alternately, you can try the auto-scanning method detailed above.


Back to previous page

© 1995 - 2009 Rogers Communications Inc.